{"id":178,"date":"2010-03-29T20:27:40","date_gmt":"2010-03-29T20:27:40","guid":{"rendered":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/cleaning-an-fns-scar-16s\/"},"modified":"2010-03-29T20:27:40","modified_gmt":"2010-03-29T20:27:40","slug":"cleaning-an-fns-scar-16s","status":"publish","type":"page","link":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/cleaning-an-fns-scar-16s\/","title":{"rendered":"Cleaning an FN SCAR 16S"},"content":{"rendered":"<p>Viewer Requested video on how to clean the FN SCAR 16S.\u00a0 Click the READ MORE below to read the article and watch the Video Portions.<\/p>\n<p>  <!--more-->  <\/p>\n<h1>How to Clean the FN SCAR 16S<\/h1>\n<p>by Jessie Indracusin<\/p>\n<h2>Introduction<\/h2>\n<p>First off, I want to say, the way this weapon was designed, it is nowhere near as finicky as an AR\/M4 direct impingement system.\u00a0 I fire TONS of dirty Wolf Ammo (yeah, strike me down with a lighting bolt, but I am a cheap ass when it comes to ammo) through the gun without any issues.\u00a0 I am a bit of a neat freak when it comes to gun maintenance, so it is definitely well maintained too.\u00a0 I&#8217;ve heard of soldiers in the field that have used this gun that really put it through the ringer without any issue.\u00a0 I had a viewer write in over the weekend asking for this and since my camera man was unavailable for doing the videos I was planning on doing, the request fit perfect for me.<\/p>\n<h2>Cleaning the Gun<\/h2>\n<p>First off, disassembly of the gun is a little different than an AR.\u00a0 You actually remove the lower receiver from the gun versus swinging it down like you do with an AR and remove the stock from the rear.\u00a0 This allows the entire bolt carrier to slide out (of course after removing the charging handle on the side.\u00a0 After all this is done, your gun should look like below:<\/p>\n<p><img loading=\"lazy\" decoding=\"async\" class=\" alignleft size-full wp-image-176\" src=\"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-content\/uploads\/2010\/03\/breakdown.jpg\" border=\"2\" alt=\" \" width=\"585\" height=\"202\" align=\"left\" srcset=\"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-content\/uploads\/2010\/03\/breakdown.jpg 585w, http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-content\/uploads\/2010\/03\/breakdown-300x104.jpg 300w\" sizes=\"auto, (max-width: 585px) 100vw, 585px\" \/>This Bolt Carrier and components below are what you need to spend your time cleaning.\u00a0 You will use a cleaning solvent over every part listed below (with the exception of the charging handle).\u00a0 Keep wiping it down with cleaning swabs until the build up on the cleaning swabs is to a minimum.\u00a0 The rest of the gun should be wiped down with a cleaning solvent on the inside of the upper and try to pick up any powder that is loose anywhere else on the gun.\u00a0 The importance of this on the rest of the gun is secondary to making sure the bolt and bolt carriers are clean.\u00a0 As far as the exterior of the gun goes, I like to use a synthetic spray cleaner to handle that.<\/p>\n<h2>Getting It All Wet and Ready<\/h2>\n<p>The key with keeping the FN SCAR 16S in good working order is to ensure that pretty much all of the above compents are lubed up pretty good, that brings us to the gun oil\/lubricant.\u00a0 I like to make my bolt coated with gun oil so that it is a wet to the touch.\u00a0 Keep in mind, the bolt is probably the most<img loading=\"lazy\" decoding=\"async\" class=\" alignright size-full wp-image-177\" src=\"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-content\/uploads\/2010\/03\/bolt.jpg\" border=\"2\" alt=\" \" width=\"337\" height=\"247\" align=\"right\" srcset=\"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-content\/uploads\/2010\/03\/bolt.jpg 337w, http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-content\/uploads\/2010\/03\/bolt-300x220.jpg 300w\" sizes=\"auto, (max-width: 337px) 100vw, 337px\" \/> critical part of a rifle to keep lubricated.\u00a0 A wet bolt means a greatly reduced chance of malfunction.\u00a0 When you put the bolt back into the carrier and insert the cross pin to lock it to the carrier, you should almost hear a squishing sound as it slides back and forth.\u00a0 I also recommend before you go to the range, drop a few more drops on the bolt before firing if it has been in storage for a long time.\u00a0 I tend to keep my guns at a constant ready firing mode and some people will comment on how my guns are almost dripping with oil (but then no one tends to complain about my guns ever jamming, unless it is a Beretta without match grade ammo).\u00a0<\/p>\n<p>After the Bolt is back in the carrier with the\u00a0cylinder cross\u00a0pin secured in the bolt, make sure you push that sliding cylinder towards the front wtih the &#8220;fin&#8221; running parallel to the bolt.\u00a0 Afterwards, you will want to put in the firing pin, also cleaned and lubed up, back into the bullet carrier with the cross bolt inserted to lock the firing pin in position.\u00a0 After the whole bolt carrier is done, I run a line of gun oil along the side of the carrier along the top half and bottom half of the bolt carrier, this would be on both sides of the bolt carrier.\u00a0 When I re-assemble the gun, I should be able to operate the charging handle over and over, releasing any loose oil and the motion should be incredibly smooth.\u00a0 At this point, you know the gun is ready for it&#8217;s next trip to the range.<\/p>\n<h2>Conclusion<\/h2>\n<p>Hope this helps anyone who is curious about cleaning this gun.\u00a0 Since it was kind of an exotic gun when I first got it, I didn&#8217;t bother writing this article since not too many people owned one at the time.\u00a0 Now that the price has come down significantly, I am sure more and more people are seriously considering this gun and possibly owning it.\u00a0 For me personally, I tend to bring this gun to the range every time I want to have a little outdoor shooting fun.\u00a0 It is a highly addictive gun to shoot, especially when you look at the recoil differences between the FN SCAR 16S and any AR platform weapon.<\/p>\n<p style=\"text-align: center;\">{youtube}<a href=\"http:\/\/www.youtube.com\/watch?v=h3BNMiX8jKw\">h3BNMiX8jKw<\/a>{\/youtube}<\/p>\n","protected":false},"excerpt":{"rendered":"<p>Viewer Requested video on how to clean the FN SCAR 16S.\u00a0 Click the READ MORE below to read the article and watch the Video Portions.<\/p>\n","protected":false},"author":1,"featured_media":176,"parent":0,"menu_order":46,"comment_status":"closed","ping_status":"closed","template":"","meta":{"footnotes":""},"class_list":["post-178","page","type-page","status-publish","has-post-thumbnail","hentry"],"_links":{"self":[{"href":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-json\/wp\/v2\/pages\/178","targetHints":{"allow":["GET"]}}],"collection":[{"href":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-json\/wp\/v2\/pages"}],"about":[{"href":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-json\/wp\/v2\/types\/page"}],"author":[{"embeddable":true,"href":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-json\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-json\/wp\/v2\/comments?post=178"}],"version-history":[{"count":0,"href":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-json\/wp\/v2\/pages\/178\/revisions"}],"wp:featuredmedia":[{"embeddable":true,"href":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-json\/wp\/v2\/media\/176"}],"wp:attachment":[{"href":"http:\/\/www.civiliantacticalweapons.com\/wpctw\/wp-json\/wp\/v2\/media?parent=178"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}